Il est, pour le moment, impossible de vérifier la tenue de la jonction jupe / fond avec un montage du fond "emmanché" dans la jupe (voir figure 16.12-3) suivant la norme NF EN 13445.

Please could we add the latest additions of PD 5500 to the design standards. In South Africa, the competing design codes are ASME and PD due to the selection of materials that our legislation permits. As a result, ensuring that Bentley AutoPIPE Ve...

To generate parts, assembly and drawings with i logic .

Add the updated code case 2901 calculation to the flange checking options

A tall vessel or column is normally designed with a particular liquid level. It would be very helpful if a new user case can be defined allowing to calculate full of liquid (which is not water, it is not the same as hydrotest).

MANDATORY APPENDIX 13 VESSELS OF NONCIRCULAR CROSS SECTION Rectangular cross section vessels.

Currently, AutoPIPE Vessel uses a default air density of 1.225 kg/m³ for wind load calculations. However, air density can vary based on the geographic location of the equipment. Therefore, I request that this value be made an input parameter inste...

Need to add an option to consider "as formed" and "annealed" bellow This will impact on following parameters and user can choose as per their requirements, ASME Km & Kg factor ASME factor 2.3 or 0.75 for Sy* EJMA Cm factor

Please add the possibility to enter the values lt, ht and eat according to EN13445 16.12.4 for the design of skirt. In my attached file, when changing lt to 179.7 mm and eat to 7.7 mm, the formula (16.12-70) is now verified without changing the sk...

Sometimes designers want to create a custom flange specially for large diameter nozzle which can then be checked as a body flange (Appendix 2 etc.). Currently this can be done as a separate model but an option to include custom flange to a nozzle ...