Please add the following features to AutoPIPE's Model Explorer: 1st approver 2nd approver Seismic code - indicate all in model to be selected Wind type - indicate all in model to be selected wave type - indicate all in model to be selected Materia...

I would like to import a Caesar II model. However, I was not able to. I asked for Bentley's tech support help, but I was directed to look at 'Import a Caesar II Neutral (CII) File' from AutoPIPE's help. It is just a general guide. There were a few...

When a bend is a miter display with the number of cuts or at least just one cut so they do not look like formed bends.

Possibility to declare bolt pre tension (eg, 40% or 50% of bolt SMYS) has to be provided in the Flange check.

Users cannot change the size of cut-short symbol. The cut-short symbol is drawn proportional to the pipe OD while in single line mode. It sometimes looks too big or too small.

I want to customize the output report items for an automation process. I'm building the system by ntl file. The dat file can customize them but the ntl file cannot.

The help file states the following for snow load analysis: Limitation Currently, AutoPIPE only considers snow loading as linear analysis. Load sequencing does not apply to snow loads and such results should not be considered. For analysis sets tha...

how to track displacements of reference points? I understand that reference points are only used to track forces and moments but i want to see separately the displacement results of these reference points instead of manually searching node by node...

Use Case: If The entire model is using plant coordinates thus causing the entire system to be off AutoPIPE's global axis. Then, if the user needs to add new piping geometry it is very difficult to model in AutoPIPE using global coordinates. Users ...

At present, the pipeline stress calculation specification is selected as the American standard, whether it is considered to refer to the Chinese standard DL/T 5366-2014. If there is no reference to this standard, then please ask whether this stand...