Working with existing or future segments in large systems, it would be great to have a option to change their segments plot (like adding transparency). Something similar to older software like Triflex (see attached image).

This is related to the limitation on the PCF Attribut Mapping tab. If we had the ability to map the PIPING-SPEC to a material then this issue would have been very easy to resolve.

When using AutoPIPE on laptop connected to a docking station or additional monitors, then removed to just using a laptop screen may cause the input / results grids to not be shown in the visible area. The grids are hidden out of screen view. Recom...

The current max length of tags is 36 characters. Tag is meanwhile just about the only play where we can save some element-specific information. For example in the case of a Support I would like to save AT LEAST the following:1) The designation of ...

I would like to import a Caesar II model. However, I was not able to. I asked for Bentley's tech support help, but I was directed to look at 'Import a Caesar II Neutral (CII) File' from AutoPIPE's help. It is just a general guide. There were a few...

Looking for an update to Import/Export the file from Auto-Pipe to UG-Nx or Vice versa. Currently there is no common format's available which will support both the software's.

There is often need to calculate two conservative thermal combinations (lowest possible assembly temperature with highest working temperature and highest assembly temperature with lowest working temperature). Now it is needed to prepare two models...

Currently, the interface between Autopipe and Openplant is disconnected. Users have to manually export piping models to Autopipe, and perform analysis. If changes need to happen in one model, the other model isnt't updated dynamically. Further, th...

By default, when you insert a WN or Lap Joint flange in Autopipe, it does not account for SIF at the BW joint. User has to enter an additional node point at a flange length and define a Joint Type with a defined offset. This could be automated.

I use Auto pipe to run stress analysis, and I always write a report summarizing the results. I always include screenshots of the restraint and supports reactions. The concentrated forces are necessary to include in the calculations, but for the sc...