Be able to model a bend at the bottom of a cone, to drain the vessel and model it up to the skirt.

Currently, AutoPIPE Vessel supports IS 1893 (Part 4) editions 2005 and 2015 for earthquake load calculations. However, the latest IS 1893 (Part 4): 2024 – Criteria for Earthquake Resistant Design of Structures, Part 4: Industrial Structures Includ...

Add the possibility to consider an external corrosion (acting on external diameters)

Implementation of PCC-1 Appendix O for bolt stress determination

Give the possibility to input the speed, which is the most common data, to supply for the deprecated functionality in the Help that helps us do the translation from speed to pressure.

Improve the guide calculation by allowing the selection of a displacement instead of a stiffness

For EN 13445, we prefer the butt weld with a relieve groove. However, some times it is needed to have the tubes as close to the shell as possible. For welded tubes to tubesheet, you can get closer to the shell with an angle type weld between the t...

Be able to check a lug or trunnion separately form a vessel inside the Component Design Module.

Ensure that all calculation codes are updated a maximum of six months after their publication

To have the painting area for each sides in case of heat exchangers (shell side / tube side)