Under File → Preferences → Set Default Data → Unit System , the M.K.S. (kgf/cm²) option is available under the Input section. However, the Output section only lists SI and US Customary . Kindly enable M.K.S. (kgf/cm²) for Output reports as well.

Add the possibility to consider an external corrosion (acting on external diameters)

Implementation of PCC-1 Appendix O for bolt stress determination

Be able to model a bend at the bottom of a cone, to drain the vessel and model it up to the skirt.

Improve the guide calculation by allowing the selection of a displacement instead of a stiffness

Ensure that all calculation codes are updated a maximum of six months after their publication

Give the possibility to input the speed, which is the most common data, to supply for the deprecated functionality in the Help that helps us do the translation from speed to pressure.

To have the painting area for each sides in case of heat exchangers (shell side / tube side)

To have the possibility to consider 3 rows of impingement rods (required by some licensors)

Be able to check a lug or trunnion separately form a vessel inside the Component Design Module.