When importing a PCF file please allow for the option to enabler "Use weight factor for bolt/nut weight" for flanges

Add the ability to model square piping / ducting

For large AutoPIPE analyses especially, it would be VERY helpful to know how long an AutoPIPE analysis took to run! I think the a log file with the time stamp, what analyses were run, and the total run time would probably be the best option. A pop...

Add a toggle between X/Y/Z and axial/shear/bending/torsion for forces and moments in the reference loads dialog. Many allowables for connections are given in terms of total shear load or bending moment. It is not possible to use the current refere...

The capability of producing FRS at some points is sometimes needed to analyze small bore branches. Generally, the small bore branches could be decoupled from the headers for seismic analysis, but these lines shall be evaluated separately using the...

Stress ISOmetric, I would like to see the trunnions shown along with their attached supports This will definitely save time having to annotate stress isos to show the missing pipe supports with the trunnions.

Currently the results summary will show the worst case for the flange. ASME B16.5 flanges combined with spiral wound gaskets will commonly fail the seating condition check with the ASME division 1 checks. This can be ignored provided the operating...

This will be a huge improvement with the ability to interact with Autopipe. Currently, users have to use a coordinate system, and map out changes to the Autopipe Mode. A feature similar to Accudraw in Microstation would significantly improve the a...

During the development of pipe design, one may need to iteratively. make small changes, and check the impact on stress, Forces, Restraint forces, etc. It would save a lot of time if there was an indicator on the default main UI that states the hig...

The current input grid is difficult to read and navigate between all the tabs. The UI elements shall be redesigned to facilitate improved navigation and data input.