Hi - is there a way to include consecutive elbows or bends in AutoPIPE? We have a model with back to back elbows and the model does not render the geometry well. Second, it appears that the Elbow forum is missing previous pages. Is Bentley still w...

Users cannot change the size of cut-short symbol. The cut-short symbol is drawn proportional to the pipe OD while in single line mode. It sometimes looks too big or too small.

Add the ability to group a selection of segments to be easily selected

It would be very handy for AutoPIPE to report the maximum loading for all load cases for reporting to the structural engineer or equipment manufacturers.

When exporting a file to a DGN, one can easily click a button to transpose the model from Y up to Z up. It would be very handy if this could be done in the AutoPIPE model itself. Then one could simply click a button to change a file from Y up to Z...

When using nonlinear analysis earthquake loads cannot be scaled. If additional analysis sets are required with different earthquake accelerations for design purposes, it is severely limiting to have only 30 E cases. There are 100 analysis sets, it...

Response spectrum analysis is a static equivalent linear analysis to a dynamic earthquake event. AutoPIPE allows the use of V-Stops with gaps for static analysis. The condition of the gap closure and subsequent support loading is determined by eva...

Modal Analysis Results to include Modes Normalized, the normalized result output would greatly help users locate which node points have the highest displacements where additional restraints could be needed to increase frequency at each mode results.

For the DXF and DGN export add new layers for Support Tag No. Anchor Tag No. Pipe Identifier Valve Tag No. Flange Tag No. etc.

In saddle support, Software considers only transversal horizontal reaction (RaH) and not taking the effect of longitudinal reactions (RaHL) while calculating the bolt tensile stress.