There is a similar idea submitted titled " Rotate command should update Anchor translational and rotational stiffness components " that could be packaged with this idea. The Rotate command should have a selectable option to apply the specified rot...

Currently, the Results Grid combines data from the Type and Symbol columns in the input grid into a single column. This makes related post-processing more difficult because the column structure differs between the input and results grids. In addit...

AutoPIPE 2026 is only able to import caesar version 14 or earlier. Add the capability to import a caesar version 15 formatted CII file into AutoPIPE

When it comes to exporting pipe support loads from AutoPIPE to STAAD, PipeLINK is an effective tool. While PipeLINK has most of the necessary functionality, there is a lack in the ability to add a Design Margin to the pipe support loads sent from ...

We typically model wall and roof penetrations as guides with clearance gaps of approximately 0.5 to 1.5 inches in all directions. These modeled clearances are then used to verify load transfer and confirm that the gaps are adequate at each penetra...

While the Attachment ID and Directional cosign information can be found in other results reports / dialogs, it would be very convenient to include both of these details on the results grids, support tab.

Similar to the attached PIPESTRESS Amplified Spectrum Generator, add a post-processing tool to AutoPIPE that can generate FRS at any node in the model (i.e., component-level FRS). This is useful when a small branch is decoupled from a large model ...

Currently, AutoPIPE calculates the gasket seating width (N) using the gasket outside diameter (OD) and inside diameter (ID), N=(Gasket OD-Gasket ID)/2. As per ASME Section VIII (Sketch 1a), the gasket seating width should be calculated based on th...

When an Anchor support is rotated using the Rotate command in AutoPIPE, the translational and rotational stiffness components do not update to reflect the new orientation. This leads to stiffness being applied in the wrong directions relative to t...

Adding an option to export the Maximum Code Stresses Color Graphics in .DGN format. The user can utilize this feature to present the code stresses in a more visual way in Navisworks.