Some manufacturer components define breakaway behavior based on applied load exceeding a specified friction force, rather than through a stiffness-based definition. After breakaway occurs, the component moves to a new position without any restorin...

Give the possibility to input the speed, which is the most common data, to supply for the deprecated functionality in the Help that helps us do the translation from speed to pressure.

We typically model wall and roof penetrations as guides with clearance gaps of approximately 0.5 to 1.5 inches in all directions. These modeled clearances are then used to verify load transfer and confirm that the gaps are adequate at each penetra...

A weld overlay is material that should not be included in strength calculations. It is used for its chemical properties. The total thickness should be used for weight calculations, while thickness - overlay thck be used for strength calculations. ...

Be able to check a lug or trunnion separately form a vessel inside the Component Design Module.

Include component calculation for plate heat exchangers as per UPX.

In previous versions of Autopipe, on wind profiles, the units for the various columns were listed with the column headers. In V25, these have been removed. There are other ways to confirm the units being used, but they take a bit of work to dig in...

When designing a vessel, several variations of a same vessels are studied. Sometimes keeping track of changes is difficult as we forget what input data was altered. Provide a comparison table of changes or another tool to compare and follow modifi...

Currently, notes can be written in Report > Miscellaneous Information. Access is not convenient. It should be just a click away.

Add the possibility to consider an external corrosion (acting on external diameters)