For large AutoPIPE analyses especially, it would be VERY helpful to know how long an AutoPIPE analysis took to run! I think the a log file with the time stamp, what analyses were run, and the total run time would probably be the best option. A pop...

New Oil and Gas projects may dry up as more countries set their sights on net zero. Along with this there is currently a massive increase in the number of large scale district heating systems in both Europe and North America. Adding EN13941 functi...

Currently the results summary will show the worst case for the flange. ASME B16.5 flanges combined with spiral wound gaskets will commonly fail the seating condition check with the ASME division 1 checks. This can be ignored provided the operating...

Add a toggle between X/Y/Z and axial/shear/bending/torsion for forces and moments in the reference loads dialog. Many allowables for connections are given in terms of total shear load or bending moment. It is not possible to use the current refere...

This will be a huge improvement with the ability to interact with Autopipe. Currently, users have to use a coordinate system, and map out changes to the Autopipe Mode. A feature similar to Accudraw in Microstation would significantly improve the a...

During the development of pipe design, one may need to iteratively. make small changes, and check the impact on stress, Forces, Restraint forces, etc. It would save a lot of time if there was an indicator on the default main UI that states the hig...

AutoPIPE error 1304731 indicates that there are improper combinations of the modal solutions for seismic anchor motions and seismic response spectra. The "fix" to the error report is a warning to the end-user; however, there is no work around. Oth...

Users can decide whether pressure extension should be considered in static analysis sets, but this is not an option for hydrotest cases. The user is required to consider it with no option to unselect "Pressure Extension" in the "Analysis Sets" int...

Stress ISOmetric, I would like to see the trunnions shown along with their attached supports This will definitely save time having to annotate stress isos to show the missing pipe supports with the trunnions.