Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

All ideas

Showing 227

Get rid of annoying windows beep sound

This is a really annoying sound. The UI shall provide a feature to disable the annoying beep sound. The attached wiki link proposes to disable Windows Sounds, but this disables all other Windows Sounds that serve a purpose outside of Autopipe. A s...
about 2 years ago in AutoPIPE / AutoPIPE Pipe Stress 0 Future consideration

Thickness required for infternal pressure - each component

Add a dialog box to see the required thickness for internal pressure for each component based on temperature and internal pressure. It is applicable for heads, shell, nozzle necks, body flanges - Like picture enclosed.
about 1 year ago in AutoPIPE Vessel 0 Future consideration

Add a feature to apply impose displacement at any node point regardless of support settings.

This is to apply at nodes where support is not applied so the user can apply imposed discplacement regardless of support setting.
about 2 months ago in AutoPIPE / AutoPIPE Pipe Stress 0 Needs review

Transport saddles calculation for vertical vessels

Add saddles for transport on vertical vessels. Calculation should be similar to horizontal vessel on saddles, but with transportation loads. This will eliminate need for an additional model for transport. Transport will be part of report and will ...
over 1 year ago in AutoPIPE Vessel 0 Future consideration

Flange analysis EN 1591-1

Include EN1591-1 calculations methodology for flanges / flange leakage Look through EN 13445-3 Annex G - Alternative design rules for flanges and gasketed flange connections
almost 4 years ago in AutoPIPE / AutoPIPE Pipe Stress 13 Planned

Non-nuclear Fatigue Analysis

I am planning to include non-nuclear fatigue in a future release. We already support ASME III NB method for nuclear and want to provide a general approach to be used with other design codes. I am looking for interest in the idea and any suggestion...
over 1 year ago in AutoPIPE / Analysis 2 Planned

speed up the analysis of large model

large dimension model have a big problem in velocity, particulary with dinamic, for the very old architecture of the software. Some common ideas: multi core implementation (a must, in my opinion) 64bit use of library for graphic cards a benchmark ...
almost 2 years ago in AutoPIPE / Analysis 1 Planned

Elastic Modulus considered for EN 13445-3 should be as per Design temperature

While designing heat exchanger as per EN 13445-3, AutoPIPE Vessel is considering elastic modulus at mean metal temperature but elastic modulus values should be taken at design design temperature. Refer attached snap.
over 1 year ago in AutoPIPE Vessel 1 Future consideration

ASME Appendix Y flange

ASME Appendix Y - Flat face flanges with metal-to-metal contact outside the bolt circle
about 1 year ago in AutoPIPE Vessel 0 Planned

Extreme fiber elongation ratio - For dished ends

The Software calculate the fiber elongation according ASME SECTION VIII division 1 according UG-79. The term “t” is the nominal thickness for the component. For dished end it is only possible insert the minimum thickness and the calculation of the...
5 months ago in AutoPIPE Vessel 0 Needs review