Valve's surface area factor should be used while applying wind loading.

When analyzing a model the following error appears: E801-5: Zero element stiffness The message does not indicate where in the model a zero element stiffness is located. Update consistency check to indicate all locations where Zero Element Stiffnes...

Under File → Preferences → Set Default Data → Unit System , the M.K.S. (kgf/cm²) option is available under the Input section. However, the Output section only lists SI and US Customary . Kindly enable M.K.S. (kgf/cm²) for Output reports as well.

There is a similar idea submitted titled " Rotate command should update Anchor translational and rotational stiffness components " that could be packaged with this idea. The Rotate command should have a selectable option to apply the specified rot...

Currently, the Results Grid combines data from the Type and Symbol columns in the input grid into a single column. This makes related post-processing more difficult because the column structure differs between the input and results grids. In addit...

AutoPIPE 2026 is only able to import caesar version 14 or earlier. Add the capability to import a caesar version 15 formatted CII file into AutoPIPE

When it comes to exporting pipe support loads from AutoPIPE to STAAD, PipeLINK is an effective tool. While PipeLINK has most of the necessary functionality, there is a lack in the ability to add a Design Margin to the pipe support loads sent from ...

We typically model wall and roof penetrations as guides with clearance gaps of approximately 0.5 to 1.5 inches in all directions. These modeled clearances are then used to verify load transfer and confirm that the gaps are adequate at each penetra...

Be able to model a bend at the bottom of a cone, to drain the vessel and model it up to the skirt.

Add the possibility to consider an external corrosion (acting on external diameters)