When exporting a file to a DGN, one can easily click a button to transpose the model from Y up to Z up. It would be very handy if this could be done in the AutoPIPE model itself. Then one could simply click a button to change a file from Y up to Z...

When using nonlinear analysis earthquake loads cannot be scaled. If additional analysis sets are required with different earthquake accelerations for design purposes, it is severely limiting to have only 30 E cases. There are 100 analysis sets, it...

Response spectrum analysis is a static equivalent linear analysis to a dynamic earthquake event. AutoPIPE allows the use of V-Stops with gaps for static analysis. The condition of the gap closure and subsequent support loading is determined by eva...

Hi - is there a way to include consecutive elbows or bends in AutoPIPE? We have a model with back to back elbows and the model does not render the geometry well. Second, it appears that the Elbow forum is missing previous pages. Is Bentley still w...

Add the ability to populate the title block information: dates, line number, etc.

The help file states the following for snow load analysis: Limitation Currently, AutoPIPE only considers snow loading as linear analysis. Load sequencing does not apply to snow loads and such results should not be considered. For analysis sets tha...

Modal Analysis Results to include Modes Normalized, the normalized result output would greatly help users locate which node points have the highest displacements where additional restraints could be needed to increase frequency at each mode results.

For the DXF and DGN export add new layers for Support Tag No. Anchor Tag No. Pipe Identifier Valve Tag No. Flange Tag No. etc.

Currently, coincident node check report only returns results for pipes nodes that are within the specified tolerance distance to another pipe node point. Suggest report also include Beam points with specified tolerance distance of other Beam point...

Once pipe properties are assigned to a run, the total length of the run with that property is calculated. For example I have 3 runs, a 2ft run, 4 ft run and 2 ft run. I assigned the property of A335P11 to the 2ft runs and SS36 to the 4ft run. Auto...