UG-98 (b) asks for taking into account the difference in elevation between the chamber being tested and the pressure gauge. The water level in test should be an input, like the liquid level in operation.

Add the ability to model square piping / ducting

After running a hanger selection analysis with the currently defined hanger analysis parameters, 1 or more possible spring hangers that meet the criteria are reported, starting with the longest range and highest spring rate and finishing with the ...

For large AutoPIPE analyses especially, it would be VERY helpful to know how long an AutoPIPE analysis took to run! I think the a log file with the time stamp, what analyses were run, and the total run time would probably be the best option. A pop...

New Oil and Gas projects may dry up as more countries set their sights on net zero. Along with this there is currently a massive increase in the number of large scale district heating systems in both Europe and North America. Adding EN13941 functi...

how to track displacements of reference points? I understand that reference points are only used to track forces and moments but i want to see separately the displacement results of these reference points instead of manually searching node by node...

The capability of producing FRS at some points is sometimes needed to analyze small bore branches. Generally, the small bore branches could be decoupled from the headers for seismic analysis, but these lines shall be evaluated separately using the...

Currently the results summary will show the worst case for the flange. ASME B16.5 flanges combined with spiral wound gaskets will commonly fail the seating condition check with the ASME division 1 checks. This can be ignored provided the operating...

Add a toggle between X/Y/Z and axial/shear/bending/torsion for forces and moments in the reference loads dialog. Many allowables for connections are given in terms of total shear load or bending moment. It is not possible to use the current refere...

This will be a huge improvement with the ability to interact with Autopipe. Currently, users have to use a coordinate system, and map out changes to the Autopipe Mode. A feature similar to Accudraw in Microstation would significantly improve the a...